How To: Install side markers

By Tucker

This Page will give you step-by-step instructions on how to install Side Markers on your delSol
	Step 1: Get all of your tools and supplies. a. (2) side markers b. Duck tape c. Masking tape d. Dermal w/ snake extension- Cutting pads e. Wire Cutters- Extra wire f. + shaped screw driver g. Wire connectors - The kind that you splice a new wire into an old wire.
	Step 2: Place duck tape all around the area you are going to cut. This will help protect the paint, incase of an accident.
	Step 3: Place Masking take over the duck tape. This will give you something to write on.
	Step 4: This part is up to you! You need to find the place you want to have your side markers. I lined mine up with the center of my front turn signal.
	Step 5: Once you found the spot for your marker, take a pen and the rubber liner and trace the hole on the tape.
	Step 6: Use the dermal and start cutting. A quick note: Always cut the hole to small. It's better to have a hole to small then one to big...!!!
	Step 7: Test fit the marker, if the hole is to small, make it bigger...If the hole is to big, well you should have read the note on "Step 6".
	Step 8: Remove the tape.
	Step 9: Add wire to the side marker, if needed.
	Step 10: Remove the mud skirt. (The rubber thing in the wheel well.)
	Step 11: Remove the front turn signals.
	Step 12: Pull the wire through the hole for the front turn signals.
	Step 13: Splice the side marker into the front turn signals. Note: There is two ways you can splice the wires... Black = Ground Green w/ yellow stripe = Flash Red w/ Black stripe = Solid
	Step 14: Test the side marker, make sure they work. (I just turned on the Four-Way-Flashers)
	Step 15: Screw the side markers in.
	Step 16: Screw the mud skirt back on.
	Step 17: Install your front turn signals....
	Step 18: Make sure everything still works....!
	Final Step : Pimp them bad boys....!!!!