1. FOLLOW INSTRUCTIONS HOW TO REMOVE GAUGE CLUSTER HERE
2. Pop the knobs off, just a little hard tug should do it
3. There are a Four clips on the top of the gauge cluster, Remove those
4. Pop the plastic shield off.
5. Remove the top metal bracket that holds the cluster to the dash by removing 2 screws.
6. Pop the other plastic piece off with a flat head screwdriver
7. Now you should be left with just the cluster and the black (if not already painted) cluster cover, remove it
8. Now you're down to the gauges! Place your indiglo gauges in, and be careful about the wiring, I had to bend it a little to get it in and set right. I used electric tape to hold the indiglo's on.. (so it does not slip around in the cluster after install)
9. Place tape over the clear area's of the indiglo.. not on the indiglo itself
10. Place the gauge cover back in, then reverse the cluster removal procedure
11.WIRING THE GAUGES: I wired mine direct to the gauge cluster. This was when my gauge goes on my indiglo's too. I did this by placing the ground (black wire) under a bolt connected to the frame the hot wire (red) I placed in the fuse spot for the gauge cluster (removed fuse wrapped wire around metal of the fuse then replaced fuse) now just set the control where you want it and you are done!
NOTE: Make sure before you place the cluster back in.. wire it up first and test it out.