I apologize for the lack of pictures...one of these days I’ll get a digicam.
1. Remove your gauge cluster (see how-to of same name).
2. Locate the plug with three connectors on it (mine was blue)...it should go into the lower left side of the gauge cluster. Connect a piece of wire to the red wire in this connector. If you want to check it and make sure you have the right wire, it should read 0V with lights full on, some +V with them in other positions.
3. Connect your piece of wire to the ground wire on the indiglo module (the little box). If it was connected to ground, detach it from wherever it was.
4. Now find your switch for the indiglos. Find the wire bundle leading to the rotary (dimmer) switch. Cut it off somewhere before the switch. There should be two small wires in the bundle. Connect them together.
5. You’re done! The dimmer switch on your dash should now work for your indiglos! Rejoice and put your dash back together (or go on to 6)
6 (opt). I also hard-wired the blue/green switch to be blue all the time since I didn’t like the green. If you want to do this, just connect the 2 wires connected to the middle of the switch to the corresponding wires on the side of the switch you want to be on all the time. This way the indiglo switches are eliminated completely (I never found a good place to put them anyway). Brian Davis (happycorepuppy)
happycorepuppy@playful.com