HOW TO make a custom trunk mat

[Boone]

First Off you need to buy a pack of foam mat. The kind you use to cover you garage floor in-front of your work bench. They look like this.



1) link 4 pieces of rubber floor mat and lay on flat working surface.

2) Remove OEM trunk carpet.

3) Place OEM carpet over rubber mat and trace with felt tip pen.

4) using an exacto / carpet / box cutter knife cut along traced outline.

5) Install in to Sol Trunk



I love this mod as it truly works for protecting you trunk when hauling parts and stuff. I liked this so much I did it in my Explorer

[Dream o_0]

awesome stuff ed

[Lil Blue]

I like it, any idea if they sell it in single sheets big enough to make one?

[Boone]

No never seen a single sheet big enough to do the Job. The pack will cost about $8.00 US

[Lil Blue]

The seam is what gets to me, I guess it could be glued so it doesn't come apart

[Boone]

It is wedged in there so tightly it does not come apart unless I take it out.

[Lil Blue]

lol, if I had something like that set up, I probably wouldn't be very careful about putting stuff in the back, lol.

Love the how to either way.

[Boone]

I did find a single sheet/role of this stuff at Big Lots. FYI it is not as thick as the stuff I used for Dys sol

[B16_Sol]

you should make one for my Sol.

[Boone]

When you are in town my friend, no problem .

[B16_Sol]

Sweet!!! I need to figure out when that will be so that people can schedule time off.

ok, back on topic, Nice work on the trunk mat Ed.